Update 4.3.0.5020 contains old version of firmware

[Richard Gration]

I have just downloaded and installed the 4.3.0.5020 update image for CS410/CS425. Although it appeared to have installed normally, I thought there must have been a problem because after rebooting the CS410, it still showed the firmware version as 4.2.1.4025. I installed the 4.3.0.5020 update again, but still the same problem.

 

So then I unpacked the .tgz update images for 4.2.1.4025 and 4.3.0.5020 and compared the contents, which were identical (except for the name of the actual ELF executable):

 

.\update\cs410.tar identical

.\update\csmencaps.ko identical

.\update\default_config.tgz identical

.\update\dhcpd identical

.\update\fxo.ko identical

.\update\insmod_driver.sh identical

.\update\ntpclient identical

.\update\pbx_install.sh identical

.\update\pbxctrl-cs410-4.2.1.4025 only in \update-4.2.1.4025

.\update\pbxctrl-cs410-4.3.0.5020 only in \update-4.3.0.5020

.\update\pbxnsip identical

.\update\rcdhcpd identical

.\update\sipfxo identical

.\update\sipfxo-3-17-2009 identical

.\update\watchdog.ko identical

 

 

Comparing pbxctrl-cs410-4.2.1.4025 and pbxctrl-cs410-4.3.0.5020 shows that (despite the different names) the contents of that ELF executable are identical.

 

Has there been a slip in assembling the .tgz update image by inadvertently packing the version 4.2.1.4025 firmware into the new image?

[pbx support]

We will double check if there was any issue in uploading or compiling.

[pbx support]

The issue has been rectified and new binary is uploaded. Thanks for checking that out.

[Richard Gration]

Thanks for that. I have installed the new .tgz 4.3.0.5020 update image and all now appears to be correct.