Jump to content

how to send a call OUTgoing over a specific port on a Sangoma gateway?


Bill H

Recommended Posts

Same question, different gateway.

 

Sangoma cards and the supporting software only allow a single port and IP Address to address up to 12 PSTN lines.

 

Can anything be done using CO1 CO2 etc... in the PBXNSIP Trunks setup to allow selective use of a trunk??

Link to comment
Share on other sites

Hello,

 

With the other windows ippbx software i work with you can address each port on the gateway from the pbx setup.

I think that makes sense.

 

I hate telling IT guys to go into the patton gateway to config it because it's like an elephant in a china shop...;-)

 

I'd love to have some way from inside pbxnsip to control outgoing and incoming routes of the gateway.

matt

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...