Jump to content

Can't call with PATTON smartnode 4112


marc
 Share

Recommended Posts

Hello,

 

 

The goal is to set up a Patton SmartNode 4112 Gateway connected to two analog telephone networks.

For the moment I made ​​test and I have at my disposal a single analog telephone network, I tried to configure but it does not work.

I can not call the server, the line is stalled but the call is not made​​.

I can call the server from outside but once picked no communication going on.

 

For information:

 

- I am in France.

- I use a snom one server, telephones snom 821 and snom m9.

- I attach the bridge configuration with this message.

 

pattonconf.pdf

Link to comment
Share on other sites

HI snomuk,

 

I tried just about every possible configuration I could think (now a sip gateway is configured), it picks up the line, messages flowing between the PBX and the bridge, but then nothing happens.

Link to comment
Share on other sites

A Sip Gateway Trunk with the Outbound proxy as the IP:port of the Gateway is all that is usualy required between snom ONE and the gateway. You will need to check that the gateway is getting connections to the FXO correctly it could be related to the Tone Generation, add a phone onto the same line as the FXO to see if any tones are been generated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...