ki4sbt Posted September 28, 2009 Report Share Posted September 28, 2009 Have a 7941G. Try the Factory reset without results. It seems to have a mind of its own. Is there a sure fire way to factory reset? Quote Link to comment Share on other sites More sharing options...
pbx support Posted September 28, 2009 Report Share Posted September 28, 2009 Have a 7941G. Try the Factory reset without results. It seems to have a mind of its own. Is there a sure fire way to factory reset? Not sure how you tried it. Check out the "Cisco 7941/7961" section in this article - https://pbxnsipsupport.com/index.php?_m=kno...kbarticleid=399. This worked all the time for us. Quote Link to comment Share on other sites More sharing options...
jlumby Posted September 28, 2009 Report Share Posted September 28, 2009 there is no sure fire way. It all depends on the software that is on it. Although holding down pound while booting, and then pressing 123456789*0# when the side lights start to flash in order down the right hand side of the screen, works on most software versions. Be prepared to have all firmware available, since it erases the flash. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.