metwest Posted September 18, 2013 Report Share Posted September 18, 2013 Hi Guys When I Auto Provision a new M9R to Snom 5.1.1 it changes the pin. I have also factory reset the M9R and the factory default pin works fine. But as soon as I re-Auto provision again it once again puts in an unknown pin. I have tried the following pins but none of the below work. Extensions PIN System Admin Password Extension Password 0000 1234 Any ideas on why it is changing the pin and what it could be? Quote Link to comment Share on other sites More sharing options...
Vodia PBX Posted September 18, 2013 Report Share Posted September 18, 2013 You can always check in the generated folder what has been generated for the extension (unless you have turned the generation off). There you usually also see the passwords. Quote Link to comment Share on other sites More sharing options...
metwest Posted September 19, 2013 Author Report Share Posted September 19, 2013 So I worked out it uses the PIN setup in General settings -> Provisioning Parameters So I guess the next question is if I forget to put something in here on a new system, what is the Snom One default PIN it assigns?? Quote Link to comment Share on other sites More sharing options...
Vodia PBX Posted September 19, 2013 Report Share Posted September 19, 2013 There is no default PIN. This is because default passwords and default PIN a an invitation for unauthorized access. The PBX actually generates a random password and AFAIK also a default PIN. Unless you disable the writing to the generated folder, the PIN can be found there. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.