Richard Samuels Posted March 9, 2009 Report Share Posted March 9, 2009 How can the MP118 FX0 be configured so that each PSTN port is addressable as a separate trunk? I want to configure Snom 360 phones with SLA and want to associate each button with a specific line. Quote Link to comment Share on other sites More sharing options...
Vodia PBX Posted March 9, 2009 Report Share Posted March 9, 2009 How can the MP118 FX0 be configured so that each PSTN port is addressable as a separate trunk? I want to configure Snom 360 phones with SLA and want to associate each button with a specific line. Hmm. Difficult topic. Ideally the PBX would register the trunk on the gateway like it would do with a service provider; not sure if that's possible. In gateway mode, it is very difficult to find out from what trunk a call comes in (they are all using the same IP address). And it is difficult to tell the gateway which line to use on an outbound trunk. Maybe the Audiocodes has a special parameter for this. Does the AudioCodes manual say anything about how this should be done? Quote Link to comment Share on other sites More sharing options...
Richard Samuels Posted March 21, 2009 Author Report Share Posted March 21, 2009 Hmm. Difficult topic. Ideally the PBX would register the trunk on the gateway like it would do with a service provider; not sure if that's possible. In gateway mode, it is very difficult to find out from what trunk a call comes in (they are all using the same IP address). And it is difficult to tell the gateway which line to use on an outbound trunk. Maybe the Audiocodes has a special parameter for this. Does the AudioCodes manual say anything about how this should be done? The people at Audiocodes gave me a recommended method. It requires entering a three digit number before the phone number, 201 for port 1, 202 for port 2, etc. How can I either set up SLA buttons on a Snom phone to send the correct three digit number or set up the trunks so that the correct number is sent? Quote Link to comment Share on other sites More sharing options...
andrewgroup Posted July 31, 2009 Report Share Posted July 31, 2009 Update on this Topic.... MP118 Audio Code.. We had a client accept our proposal, and the original proposal had assumed the the current 8 line configuration would become an 8 line incoming hunt group. We now suddenly have to deal with duplicating the old config.... Lines 1 thru 4 go to a hunt Group.. Lines 5 through 8 each are stand-alone lines that are to ring specific extensions.... to complicate matters, we now must forward calls to a third party voice mail and if possible us the CENTREX single line transfer feature using the FLASH Option.... did the registration of different lines on the MP11X work as expected? Cheers - A.T. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.