sandsvoip Posted February 7, 2011 Report Share Posted February 7, 2011 I have configured the patton as an extension to the snom pbx. However, I get no audio from this door bell. Please send me in te correct direction. The trunk is ok, registered, rtp ports are set, registration is ok on both the patton and the pbx... Any other suggestions? Quote Link to comment Share on other sites More sharing options...
Vodia PBX Posted February 7, 2011 Report Share Posted February 7, 2011 Is it no audio or one way audio? If you have a setup with multiple IP addresses (private, public, VPN, ...) the routing could be a problem. First step should be to get it working in the LAN, then if that works you can complicate the setup and put the device behind NAT. Quote Link to comment Share on other sites More sharing options...
mattlandis Posted February 7, 2011 Report Share Posted February 7, 2011 i think we had this issue with Patton M-ATA as well. I can't think off hand what it the solution was but we did get it working. It was a config issue and I think surrounding port on the M-ata. I would suggest connect with Patton. They have excellent support. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.