Auto Provisioning on Version 63.0.4

[Rameshkumar]

Hi, I upgraded PBX to version 63.0.4. I provisioned my yealink phone and it get provisioned. But before if I open extension for provisioning and then put the URL in browser "https://{PBX-IP}:443/yealink-001565A95ABE.cfg" I was able to open cfg file on my computer and I was able to check config file. Right now if I open it into the browser it ask for username and password (even extension is open for provision) and username password is not working at all Please advise

[Support]

Hi,

 

1) You can try to switch to http instead of https and try it.

2) The username and password are the one that you set on the domain settings > Provisioning parameter. Make sure you're entering that.

[Rameshkumar]

I tried both things but no luck. It's still asking for the username password.

[Support]

Can you try the username as the mac address?

 

[Rameshkumar]

It's the same-thing. Logically when extension is open for provision it should not ask for username and password.

[Rameshkumar]

Hi, any update on this matter?

[Vodia PBX]

Looking at the ticket wondering what you are trying to achieve - if you want to see what the PBX sends to the phone you can do this easily in the page where you enter the MAC for the phone - there is lists the files that were sent to the phone. You can click the view button then it shows a pop-up with the content.

[Rameshkumar]

It's good . Thanks for your help.